Aluminum cam and groove (camlock) fittings follow strict interchangeability and construction standards like Commercial Item Description A-A-59326D (which supersedes military spec MIL-C-27487) and EN 14420-7 / DIN 2828. They offer lightweight, corrosion-resistant quick-disconnect performance for fluid handling. Core Material & Design Standards • Body Material: Aluminum Alloy (typically permanent mold or gravity cast A356 or A380) for high strength-to-weight ratio. • Cam Arms / Levers: Brass, stainless steel, or aluminum. • Pins and Rings: Stainless steel pins, rings, and safety clips. • Standard Gaskets: NBR (Buna-N / Nitrile) standard; EPDM, Viton, or PTFE optional. Operating Parameters • Size Range: 1/2 inch up to 6 inch (DN15 to DN150). • Maximum Working Pressure: Varies by size, typically up to 150 to 250 PSI (higher for smaller sizes, lower for 4'–6' lines) at ambient temperature. • Temperature Range: -40°C to +100°C (-40°F to 212°F) using standard Buna-N seals. • Prohibited Media: Do not use with compressed air or steam due to severe safety hazards upon joint failure. Common Configuration Types • Type A: Male adapter x Female NPT/BSPT thread. • Type B: Female coupler x Male NPT/BSPT thread. • Type C: Female coupler x Hose shank (crimp or band clamp). • Type D: Female coupler x Female NPT/BSPT thread. • Type E: Male adapter x Hose shank. • Type F: Male adapter x Male NPT/BSPT thread. • Type DP / DC: Dust plug and dust cap. If you need specific details, please specify:The fitting size and type (A through F) requiredThe application or fluid being transferred